Endress + Hauser 5WBB3F-GRIDDMHN1AHA1KGAA1
Electromagnetic flowmeter
Inline version.
Application: Suitable for elementary
measurement tasks
such as raw water intake.
International drinking water approvals.
Installation length: DVGW/ISO conform.
App; display and touch screen optional.
Communication: HART or Modbus RS485.
:: Basic meter f. Water + Wastewater
with easy-to-use operation concept.
5WBB3F-4P35/0
Endress Hauser 5WBB3F
GR Approval; Transmitter + Sensor: EAC; Non-hazardous area
I Design: Fixed flange, 0 x DN inlet/ outlet runs
D Functionality: Enhanced transmitter
D Power Supply: 24VDC
M Output; Input: Modbus RS485, 4-20mA
H Display; Operation: W/o; SmartBlue app
N Housing: Remote, polycarbonate
1 Cable, Sensor Connection: 5m/15ft coil and signal cable
A Electrical Connection: Gland M20
H Liner: Hard rubber
A1K Process Connection: Cl.150, carbon steel, flange ASME B16.5
G Electrodes: 1.4435/316L, bullet nose
A Calibration Flow: 0.5%
A1 Device Model: 1
Details: Volume flow unit: m3/h
Mass flow unit: t/h
Conductivity unit: μS/cm
Baud rate: Bd19200
Parity: Even
Byte order: BO 1-0-3-2
Failure mode: Stop
Totalizer 1: null
Unit: m3
Operating mode totalizer: Net flow total
Failure mode: Stop
Totalizer 2: null
Unit: m3
Operating mode totalizer: Forward flow total
Failure mode: Stop
Totalizer 3: null
Unit: m3
Operating mode totalizer: Reverse flow total
Failure mode: Stop
Instruments with a nominal diameter > DN25 and for process pressure > 0,5 bar may fall into the scope of the pressure equipment directive (PED) 2014/68/EU, but this option according to PED is not selected. However, the devices are designed and manufactured according to common engineering practice and therefore comply to the requirement following Article 4 (3) of the PED. The permissible area of application can be found in the diagrams 6 to 9 in the annex II of the directive.
